The Solar Ground Pile Mounting System uses Pile drivers to drive C-beams, H-beams or other structural steel directly into the Ground. Installation is simple. This type of installation is widely used in many uneven terrain. Using a pile driver to drive steel piles into the soil, there is no need to dig the ground, more environmentally friendly, not subject to seasonal temperature and other restrictions. Kinsend improves the strength of the ramming pile system to fix the portrait beam onto the post by special designed clamps, with force at the same direction of the gravity.The system compatible with most kinds of framed and frameless modules.
Installation Site
Open Field Area, Level Ground or Slope Ground
Installation Base
Piling
Tilt angle
0°- 45°
Max Wind Speed
< 60m/s
Snow Load
< 80cm
Standards
AS/NZS 1170 &JIS C 8955-2011
Material
Al6005-T5 for aluminum profiles and clamps
Stainless steel for fasten bolt and nut
Hot Dip galvanized Q235 for U Pile Post
Anti-corrosive
Anodized
Warranty / Duration
12 years/ More than 25 years
Component List